Mercury ALPHA Spezifikationen PDF herunterladen (Seite 97)

CB820

Changing Fluids

Refer to Maintenance for change interval. Crankcase oil should be

changed before placing boat in storage.

Power Trim or Power Steering fluids do not require changing.

Changing Crankcase Oil and Filter

IMPORTANT: Change crankcase oil when engine is warm from

operation. Warm oil flows more freely, carrying away more

impurities. Use only recommended engine oil (refer to

Specifications).

1 With engine at normal operating temperature, remove drain plug

from oil drain hose or remove dipstick.

NOTE: If engine is factory equipped with Quick Drain Oil Hose, pull

tether through bilge drain before removing drain plug from oil drain

hose.

2 Drain crankcase oil using quick drain oil hose.

NOTE: If drain plug is not accessible because of boat construction,

oil may be removed through dipstick tube, using a Quicksilver

Crankcase Oil Pump. (See Quicksilver Accessory Guide.)

3 Drain crankcase oil using Quicksliver Crankcase Oil Pump.

A Insert hose end of crankcase oil pump onto an appropriate

container and using handle, pump until crankcase is empty.

B Remove pump.

4 After oil has drained completely, reinstall drain plug or dipstick and

tighten securely.

5 Remove and discard oil filter and its sealing ring.

6 Coat sealing ring on new filter with engine oil and install. Tighten

filter securely (following filter manufacturer’s instructions). DO NOT

overtighten.

7 Remove oil filler cap. Add recommended engine oil to bring level

up to, but not over, FULL or OK RANGE mark on dipstick. Refer to

Specifications.

8 Start engine and check for leaks.

IMPORTANT: Always use dipstick to determine exactly how

much oil is required.

INDEX

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 180 181

Keine Kommentare

Mercury ALPHA Spezifikationen Seite 97