Mercury ALPHA Spezifikationen PDF herunterladen (Seite 155)

153

CA854

3.0L Single Point Drain

CAUTION

Ensure bilge pump is operating before beginning procedures.

Excess water in bilge can damage engine or cause boat to

sink.

CAUTION

Allow engine to cool down before disconnecting blue drain

hoses. Engine water temperature can exceed 160° F ( 71° C).

CAUTION

Do not operate engine with blue drain hoses disconnected.

Hot water can discharge violently.

IMPORTANT: Do NOT start or operate engine at any point in this

procedure.

1 Turn on bilge pump.

2 Push quick connect fitting release buttons (A) and remove blue

drain hoses (B) from the bracket.

3 Pull T-handle (A) until the hose guide (B) is in contact with the

quick connect fittings.

4 Push down on T-handle to force the blue drain hoses below their

connection points to the block (A).

5 Ensure water is draining from both blue drain hoses. If water is not

draining from one or both blue drain hoses, go to Clearing Clogged

Blue Drain Hoses”

6 Leave blue drain hoses disconnected until all water has drained

from engine.

7 Pull T-handle until the quick connect fittings (A) on the blue drain

hoses are within reach.

8 Install quick connect fittings on the bracket. Pull on the blue drain

hoses to ensure they are firmly connected.

9 Push down on handle and move into the slot on the bracket.

10Turn off bilge pump.

IMPORTANT: The next time the engine is started, visually

inspect that the blue drain hoses are connected and not leaking.

INDEX

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 180 181

Keine Kommentare

Mercury ALPHA Spezifikationen Seite 155