Mercury ALPHA Spezifikationen PDF herunterladen (Seite 143)

141

IMPORTANT: Before starting engine, a water source must be

attached to the seawater intake openings in gear housing,

and/or seawater pickup pump. Follow all warnings, and

flushing attachments procedures stated, in Flushing Cooling

System.

CAUTION

Sterndrive unit should be stored in full DOWN position. Uni-

versal Joint bellows may develop a set if unit is stored in

raised position and may fail when unit is returned to service.

1 Fill fuel tanks with fresh gasoline (that does not contain alcohol)

and a sufficient amount of Quicksilver Gasoline Stabilizer for Marine

Engines to treat gasoline. Follow instructions on container.

2 If boat is to be placed in storage with fuel containing alcohol

in fuel tanks (if fuel without alcohol is not available): Fuel tanks

should be drained as low as possible and Quicksilver Gasoline

Stabilizer for Marine Engines added to any fuel remaining in the tank.

Refer to Fuel Requirements for additional information.

NOTE: If desired, a portable fuel tank can be used to perform the

remainder of the power package lay up procedures. Be sure to add

an appropriate amount of Gasoline Stabilizer to the portable tank.

3 Run engine sufficiently to bring it up to normal operating

temperature and allow fuel with Quicksilver Gasoline Stabilizer to

circulate thru fuel system. Shut off engine.

4 Change oil and oil filter.

5 Flush cooling system. Refer to Flushing Cooling System

procedure shown earlier in this manual.

6 Proceed to the following instructions appropriate for your model,

for additional fuel system preparation.

INDEX

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 180 181

Keine Kommentare

Mercury ALPHA Spezifikationen Seite 143