Mercury ALPHA Spezifikationen PDF herunterladen (Seite 109)

107

CA938

Drive Unit and Transom Assembly

1 Lubricate gimbal bearing by applying approximately 8-10 pumps

of grease from a typical hand-operated grease gun using Quicksilver

U-Joint and Gimbal Bearing Grease.

A Alpha Models - Lubricate hinge pins by applying a couple of

pumps of grease from a typical hand-operated grease gun using

Quicksilver 2-4-C Marine Lubricant with Teflon.

2 For propeller shaft lubrication, see PROPELLER.

CA929

Engine Coupler

3 Lubricate engine coupler splines through grease fittings on

coupler by applying approximately 8-10 pumps of grease from a

typical hand-operated grease gun using Quicksilver Engine Coupler

Spline Grease. If boat is operated at idle for prolonged periods of

time, coupler should be lubricated Bravo Models - every 50 hours;

Alpha Models - every 150 hours.

NOTE: Alpha Models - Your engine is equipped with a sealed

engine coupler and Perm-a-Lube U-joints. The sealed coupler and

shaft splines can be lubricated without removing the drive unit. The

Perm-a-Lube U-joints do not require lubrication.

NOTE: Bravo Models - Your engine is equipped with a sealed

engine coupler. The sealed coupler and shaft splines can be

lubricated without removing the drive unit.

NOTE: Bravo Models - The crosses and bearings on the drive

U-joint will need to be lubricated through the grease fittings. Apply

Quicksilver U-joint and Gimbal Bearing Grease from a typical hand-

operated grease gun until a small amount of grease begins to push

out. The sterndrive unit must be removed to grease these fittings.

CB777

Drive Shaft Extension Models

4 Lubricate drive shaft grease fittings, at transom end, by applying

approximately 10 - 12 pumps of grease from a typical hand-operated

grease gun using Quicksilver U-joint and Gimbal Bearing Grease.

5 Lubricate drive shaft grease fittings, at engine end, by applying

approximately 3 - 4 pumps of grease from a typical hand-operated

grease gun using Quicksilver U-joint and Gimbal Bearing Grease.

INDEX

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 180 181

Keine Kommentare

Mercury ALPHA Spezifikationen Seite 109