Mercury 200 Optimax Installationshandbuch PDF herunterladen (Seite 19)

200/225/250 OPTIMAX

Page 19 of 38

•

Turn the ignition key switch back to the OFF position, and squeeze the primer bulb again

until it feels firm. Turn the ignition key switch to the “ON” position again for three seconds.

Continue this procedure until the fuel line primer bulb stays firm.

Oil Injection Set-Up

1. Fill remote oil tank with the recommended oil listed in the Operation and Maintenance

Manual. Tighten fill cap.

a-Fill Cap

2. Remove cap and fill engine oil tank with oil. Reinstall the fill cap.

a-Engine Oil Tank

b-Fill Cap

Priming the Oil Injection Pump

Before starting engine for the first time, prime the oil injection pump. Priming will remove

any air that may be in the pump, oil supply hose, or internal passages.

57916

a-Oil Injection Pump

b-Oil Supply Hose

CAUTION

To prevent damage to the fuel pumps, fill the engine fuel system with fuel. Other-

wise the fuel pumps will run without fuel during the priming process.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Keine Kommentare

Mercury 200 Optimax Installationshandbuch Seite 19