Mercury 200 Optimax Installationshandbuch PDF herunterladen (Seite 18)

200/225/250 OPTIMAX

Page 18 of 38

4. Check throttle cable adjustment as follows:

a. Shift outboard into gear a few times to activate the throttle linkage. Make sure to ro-

tate the propeller shaft while shifting into reverse.

b. Return remote control to neutral. Place a thin piece of paper between idle adjust-

ment screw and idle stop. Adjustment is correct when the paper can be removed

without tearing, but has some drag on it. Readjust cable barrel if necessary.

IMPORTANT: The idle stop screw must be touching the stop.

a-Idle Stop Screw

b-Idle Stop

5. Lock the barrel holder in place with the cable latch.

Filling Fuel System

NOTE: For initial start of a new engine or for an engine that ran out of fuel, or was drained

of fuel, the fuel system should to be filled as follows:

•

Squeeze the fuel line primer bulb until it feels firm.

•

Turn the ignition key switch to the ON position for three seconds. This operates the elec-

tric fuel pump.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Keine Kommentare

Mercury 200 Optimax Installationshandbuch Seite 18