Mercury D2.8L D-Tronic Spezifikationen PDF herunterladen (Seite 45)

ON THE WATER

SECTION 3

9CMD-4081850 / 90-860094030 SEPTEMBER 2003 Page 37

Mechanical Engine Stop Lever - located on the injection pump of all engines except D-Tronic

Engines. It is used to manually shut off engine by cutting off the fuel supply. It can be

engaged by moving the lever in the direction shown.

76378

71386

D4.2L Models D4.2L LD and D4.2L 230 Models

BEFORE STARTING THE ENGINE

CAUTION

Do not operate engine without water flowing thru seawater pickup pump, as pump

impeller may be damaged and subsequent overheating damage to engine or drive

unit may result.

IMPORTANT: Observe the following before starting:

• Provide water to the seawater pickup pump.

• Never operate the starter motor longer than 15 seconds at a time, to avoid

overheating the starter motor. If engine does not start, wait 1 minute to allow

the starter motor to cool; then, repeat starting procedure.

• Be sure engine crankcase is filled to correct level with the proper grade of oil

for the prevailing temperature. Refer to Fluid Capacities - Engine Oil.

• Be sure that all electrical connections are secure.

• Check the air cleaner for proper installation of filter element.

3. Check all items listed in the Maintenance Schedules and Operation Chart - D4.2L,

D4.2L LD, and D4.2L 230. Refer to the Table Of Contents.

4. Perform any other necessary checks, as indicated by your dealer, or specified in your

boat owner’s manual.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 159 160

Keine Kommentare

Mercury D2.8L D-Tronic Spezifikationen Seite 45